Eneo HDC-2180Z03 D - Manual (Page 13)

Operating Instructions
13
FULL-HD AF ZOOM CAMERA
SAVE & EXIT – Exits the menu after saving the parameters.
EXIT – Exits the menu without saving the menu.
EXIT
ZOOM / FOCUS
FOCUS MODE
D-ZOOM
HOME POSITION
LENS REFRESH
LENS INIT.
RETURN ZOOM PUSH
OFF
OFF
OFF
ON
☟
RET
• ZOOM PUSH: Focusing is activated only when zoom in/out is working.
• AUTO: Focusing is always working.
• MANUAL: Focusing can only be adjusted by ▲,▼ of OSD control joystick
or the remote control via RS-485.
• O-ZOOM RATIO: Sets the Optical ZOOM positon as Home Position.
(x1.0~x3.0 / x1.0~x2.4)
• DURATION: When ZOOM IN/OUT control is accomplished, camera returns to
pre-defined Zoom position after Duration time.
If SMART MOTION / PRESET ZOOM are running, duration for Home position
starts after finishing SMART MOTION / PRESET ZOOM.
1. ZOOM/FOCUS
: ZOOM PUSH, AUTO and MANUAL modes are available for focusing.
1-1. FOCUS MODE (default: ZOOM PUSH)
: D-ZOOM(Digital zoom) is available up to 32x. D-ZOOM starts working when
the optical zoom reaches its maximum tele-position. Zoom ratio is displayed
on the right bottom corner of the monitor if SPECIAL>DISPLAY>ZOOM RATIO
is set to ON.
1-2. D-ZOOM (default: OFF)
: Camera can be configured to return to pre-defined Zoom position automatically
after certain period since ZOOM IN/OUT control is accomplished.
Home Position is recovered even after camera is re-initializing or Power ON/OFF.
1-3. HOME POSITION (default: OFF)