ATL Telecom Berkshire 200 - Manual (Page 3)

and replace the handset.
• FrOm heaDseT TO hanDseT
If you wish to transfer a call from your headset
to the handset, simply pick up the handset. This
action will switch off the headset.
Features and Facilities
TransFer keY (reCall)
Berkshire 200 telephones are provided with a
‘TransFer’ key, required by modern public and
private exchanges, in order to gain access to
various features such as ‘transferring a call’. For
this, the 2 position selector switch at the rear of the
telephone, must be set to the ‘T’ (Time Break recall)
or ‘e’ (earth leg recall) position, to suit your system
requirements.
reDIal keY
If you wish to redial the last number you dialled, you
can do so by lifting the handset and pressing the
‘reDIal’ button.
mUTe keY
The microphone in the handset / headset can
be turned off (mute) in order for you to refer to a
colleague without your caller hearing you.
• pressing the ‘mUTe’ button turns off the
microphone and gives visual leD indication within
the ‘mUTe’ button.
• pressing the ‘mUTe’ button again turns the
microphone back on and the leD is turned off.
sWITChaBle messaGe WaITInG
There are three versions of message Waiting
Indication supported within the Berkshire 200
telephone (mW3, 8 and 10). This selection is made
via a 4 position switch located to the rear of the
phone, indicated by the letters ‘mW’.
a ‘rInG InDICaTOr’ setting is provided that has
additional benefit of being activated by short ring
burst mW signals - see website for details.
In all cases, an leD in the top right hand corner
of the telephone is used to indicate the selected
functions and incoming calls.
any questions you may have should be directed
in the first instance to your telephone supplier with
details of your paBX.
Further concerns may also be addressed by
calling our Technical Support Department
on 0845 421 0730 or visiting our website,
www.atltelecom.com/support.
mODem pOrTs
Your Berkshire 200 comes with two modem ports
(Bs6312 and rJ11) typically used for a pC modem,
or as points of connection for additional telephones.
hearInG aID COmpaTIBIlITY
For hearing aid users, an inductive coupler has
been installed in the handset of the Berkshire 200,
to improve audible efficiency.
Installation Notes
messaGe WaITInG
mW3 is used by systems that use high voltage
DC signalling. mW8/10 however use line reversal
methods to indicate that a message is present.
please check with your TelecomTeam/provider for
correct settings as it will depend on what switchboard
you are connected to.
Help
If the telephone appears to be faulty when first
connected, a few simple checks may help to identify
some possible problems, as listed below:
nO DIal TOne
• The handset is plugged into the handset socket
not headset socket.
• Check that the telephone plug is fully inserted in
the socket.
• If it is, try connecting the telephone into another
socket, if available. If dial tone is now heard, the
original socket is faulty.
• alternatively, try connecting another telephone
into your socket. If this telephone gives dial tone,
then your new telephone is probably faulty.
all OperaTIOns seem saTIsFaCTOrY
eXCepT The TransFer BUTTOn
• Change the recall selector switch setting (T/e).
If the transfer operation is now satisfactory, the
problem is resolved.
For help with voicemail, call divert and call pickup
please contact your Telecom Team/provider as this
will vary depending upon what switchboard you are
connected to.