Aqua Lung Dimension i3 / Lotus i3 BC - Manual (Page 12)

English
© 2012 Aqua Lung International
BC
Home
ROUTING & ATTACHING THE MP INFLATOR HOSE (i3 INFLATOR)
1. After attaching the BC and regulator to a cylinder,
make sure the bladder is completely deflated.
3. Route hose through the sleeve behind the pocket.
Remove the dust cap from the quick disconnect plug
on the i3 control unit.
4. Grab the hose grip between your thumb and forefinger,
then slide the sleeve back.
2. Route the MP hose through the rear slot at the top
of the BC bladder and down the left side.
NOTE: Keep the dust cap on while not in use.