Allmand Brothers NIGHT LITE PRO LD - Manual (Page 11)

NIGHT-LITE PRO SERIES
* Use these codes to designate color needed:
01-White 06-Allmand Gold
02-Gloss Black 09-Flat Black
03-Gray 10-High temp Black
04-Allmand Yellow 11-Red
05-Orange 12-Chrome
15-Plated
ELECTRIC WINCH STRAIGHT CORD TOWER CABLE ROUTING
B-4B
LEGEND: NS= Not Shown
** = Purchase locally
1 2 620084 WIRE ROPE CLIP 3/16"
2 1 045040 WIRE ROPE THIMBLE, 1/4"
3 1 650438 MAST WIRING - 14/7 X 324" (4-LIGHT)
4 1 320185
5 1 352054 STEEL CABLE 7/32" X 26'
NS 650429* ELECTRIC WINCH, STRAIGHT CORD TOWER COMPLETE
WITH 4-LIGHT LIGHT BAR ASSEMBLY
NS 650343* ELECTRIC WINCH, STRAIGHT CORD TOWER COMPLETE
WITHOUT LIGHT BAR ASSEMBLY
INSTRUCTIONS FOR REPLACING STEEL CABLES
3/16 X 10'
REMOVE THE CUSHION CLAMPS AND MAST WIRING FROM 3" MAST SECTION.
REMOVE LIGHT BAR BY REMOVING 4 NUTS ON BAR AND LAY BAR ON GROUND.
REMOVE THE WIRE ROPE CLIPS AT TOP END OF THE 4" MAST SECTION.
REMOVE THE 3" PULLEY AT THE END OF THE 3" MAST SECTION.
REMOVE THE 2 5/8" ROUND MAST SECTION.
REMOVE ALL BROKEN AND FRAYED CABLE.
REPLACE NEW CABLE THROUGH SLOT AND EYELET IN THE ROUND MAST SECTION.
REPLACE 2 5/8" ROUND MAST SECTION IN THE 3" MAST SECTION.
ROUTE CABLE THROUGH PULLEY BRACKETS AND INSTALL 3" PULLEY.
WITH ALL SECTIONS PUSHED TOGETHER TIGHT, INSERT CABLE THROUGH HALF-LINK
AND REINSTALL WIRE ROPE CLIPS.
REINSTALL CUSHION CLAMPS AND MAST WIRING ON THE 3" MAST SECTION.
7/32 X 26'
REMOVE CABLE FROM WINCH.
REMOVE MAST WIRING FROM BALLAST COMPARTMENT (SEE ELECTRICAL SCHEMATIC)
REMOVE TOWER ASSEMBLY FROM TRAILER.
REMOVE STOP BOLT AND WASHER.
REMOVE 4 NYLON ROLLERS AND 3" PULLEY AT TOP END OF 3" SQUARE SECTION.
REMOVE THE 2 5/8" ROUND AND 3" MAST SECTIONS TOGETHER.
REMOVE 2 1/2" PULLEY FROM END OF 4" SECTION.
REMOVE ALL BROKEN AND FRAYED CABLE.
REPLACE NEW CABLE THROUGH SLOT AND EYELET IN THE 3" MAST SECTION AND
THROUGH PULLEY BRACKETS.
REPLACE 2 5/8" ROUND AND 3" MAST SECTIONS.
REPLACE 3" PULLEY AND 4 NYLON ROLLERS.
REPLACE STOP BOLT AND WASHER.
RUN NEW CABLE ON OUTSIDE OF 4" SECTION.
REPLACE 2 1/2" PULLEY.
REPLACE TOWER ASSEMBLY ON TRAILER.
REPLACE MAST WIRING IN BALLAST COMPARTMENT. (SEE ELECTRICAL SCHEMATIC)
RUN NEW CABLE THROUGH PULLEY BRACKETS IN FRONT OF TRAILER.
ATTACH CABLE TO ELECTRIC WINCH.
WIND IN CLOCKWISE DIRECTION UNTIL ALL SLACK IS OUT.
NO REQ’D PART NO DESCRIPTION