How to assemble and use – Eureka 6900 Series User Manual
Page 6
Power-Touch
Hose Handle
How to Assemble and Use
POWER-TOUCH
®
Handle
Remote ON/OFF Selector for bare floor or carpet
*Off – push down on front
Bare Floor – push down on back
*Power ON/OFF can be controlled on some models from the POWER-
TOUCH handle switch or canister ON/OFF switch. Other models can
only use the canister switch.
Vacuum Control
Cleaning suction is reduced by pushing lever
to LOW position. Place lever at HIGH position
to increase suction for carpet cleaning.
Available on models without Remote Speed
Control.
1. Snap interlocking wands together.
2. Push assembled wands into power nozzle.
3. Place Power-Touch hose handle into wands until plug connects and
button locks.
4. Insert hose coupling into top of canister and push hose power cord into
receptacle located near the canister handle.
5. Pull on electrical cord and push plug into outlet. To rewind, step on
Cordaway cord reel button, hold and guide plug while it rewinds.
6. Step on handle release to release handle; pull back to comfortable work
position.
7. Push On/Off canister switch.
(A thermostat automatically shuts off the motor if it overheats, see
Automatic Motor Shut-Off,)
8. Bare floor or carpet cleaning selection on remote control, only.
6
ON
Select bare floor or
carpet cleaning
Handle Release
NOTE: Optional remote controls on the hose handle
operate only if the canister switch is on.
O
F
F
3
1
9
8
5
6
2
7
The Quick Release foot pedal allows the user to easily
remove the motorized power nozzle for above the floor
cleaning.
To disconnect power nozzle, step down on rear of the
quick release foot pedal and pull up on wands.
Quick Release
Foot Pedal