Airlink RT210W - Manual (Page 54)

Wireless Broadband Router User Manual
44
the Wireless Broadband Router how to direct traffic across
networks.
Item Description
Outbound Protocol Specifies the protocol the application
uses. TCP or UDP
Outbound Port
Start/End Enter the WAN port range from which
data that follows that particular protocol
should be sent.
Inbound Protocol Select the protocol (UDP or TCP) for the
port.
Inbound Port
Start/End Enter the WAN port range from which
data that follows that particular protocol
will return.
To Port Start/End Enter the LAN port range.
Enabled Select this option and click Apply to
activate the configuration.
u
Static Routes
In this section, the user can define static routes for incoming packets.
To define a static route, enter the following information:
Item Description
IP Address Enter the network address of the destination
computer.
Subnet
Mask Enter the subnet mask of the destination computer’ s
network address
Gateway Enter the router’ s IP for the destination computer.
Metric Enter the number of transmission hops (range 0 ~
15).
Interface Select whether the destination computer is located on
the WAN or LAN interface.