AIRLESSCO G-Force II 2525 DD - Manual (Page 18)

Troubleshooting
18 333031E
Water in pump oil Humid air condensing inside crank-
case Change oil as specified in Mainte-
nance on page 15.
Worn packings Install new packings.
Oil seals are leaking Install new oil seals.
Packings failing frequently or prema-
turely Scored, damaged, or worn plungers Install new plungers.
Abrasive material in the fluid being
pumped Install proper filtration on pump inlet
plumbing.
Inlet water temperature too high Check water temperature. It should
not exceed 140°F (60°C).
Over pressurized pump Do not modify any factory-set adjust-
ments. See Equipment Misuse Haz-
ard on page 6.
Excessive pressure due to partially
plugged or damaged nozzle Clean or replace nozzle. See Nozzle
Connection on page 10.
Pump running too long without spray-
ing Never run pump more than 10 min-
utes without spraying.
Running pump dry Do not run pump without water.
Strong surging at inlet, and low pres-
sure on discharge side Foreign particles in the inlet or dis-
charge valve, or worn inlet and/or
discharge valves Clean or replace valves.
Problem Cause Solution