ACTi PMON-1001 - Manual (Page 10)

www.acti.com
PMON-1001 Product Manual
10
1) Antenna Lock
This switch locks the antenna to keep it firmly mounted to the PMON-1001.
2) Reset Button
It resets the PMON-1001 back to factory default configuration. It can be used when the device
is not behaving normally and there are no other ways to restore normal working condition.
The procedure of reset:
1. Power up the unit
2. Wait 1 minute
3. Press the Reset Button using a pin and hold it for 5 seconds.
4. Release the button. The unit will restore the settings to factory default and reboot.
3) Power LED
Power LED ON indicates that the
Wireless AP module of PMON-1001 has
been powered on. Power LED OFF
indicates that the device has been
turned off.
4) System Ready LED
The System Ready LED turns ON when
the Wireless AP system has been
booted up completely. If this LED does
not automatically turn ON after Power
LED is already ON, then the system boot up has failed. In such case, try to Reset the device.
5) Ethernet Connected / Data Transmission
The ENET LED ON means that the
camera has been connected to
PMON-1001 through Ethernet port. The