ACTi IP Utility V4.3.03 - Manual (Page 19)

www.acti.com
IP Utility User’s Manual 4.3.03
19
Rebooting the Devices
There are chances that certain devices need a refresh cycle; IP Utility allows you to save &
reboot many devices in a go.
1. Select the devices.
2. On Configuration Tool Bar, click “Save & Reboot”. In this case, you may choose to reboot
the device while saving all current setting.
If you simply want to clear all the settings on the device to start over again, “Resetting” can
restore its factory default values except network settings. Therefore, this device still uses the
same IP address after resetting.
NOTE : The “Save & Reboot” or “Reset” process isn’t completed until the device status
displays a success message. During this period, please do not disconnect the device.