Step 2: install the new ethernet cable, Hardware manual – ACTi E31 User Manual
Page 21
Hardware Manual
Step 2: Install the New Ethernet Cable
1.
Insert the new Ethernet cable through the sealing nut, claw, seal, and cable
gland of the back cover.
2.
Attach the RJ-45 connector to the Ethernet cable. See
on page
34 for more information.
3.
Assemble the seal and claw, and then connect the RJ-45 connector to the
Ethernet port inside the camera.
4.
Attach the back cover by tightening the three (3) screws.
NOTE:
Make sure the rubber ring on the cover is secured and the screws are
completely tightened to avoid possible water leak.
2
2
1
2