Step 1: attach the corner mount, Corner mount with heavy, Duty and mount kit – ACTi Indoor PTZ on Corner Wall with Accessory Sets of PMAX-0305 User Manual

Page 4: Installation procedures

Installation Guide

Corner Mount with Heavy Duty and

Mount Kit Installation Procedures

Perform the following procedures to install the camera on a corner wall using the Heavy Duty

Wall Mount and Mount Kit. The cables go along the wall then enter the Heavy Duty from the rear

side and through the Mount Kit and the camera.

Step 1: Attach the Corner Mount

Align the Corner Mount to the corner wall and mark the location of the eight (8) screw holes.

NOTE:



The illustration above shows only the screw holes on one side of the wall.

Remember to mark the screw holes on the other side of the wall, too.



Due to different corner surfaces and shapes, it is recommended to use the

actual Corner Mount to mark the holes for drilling.

Drill the eight (8) screw holes.

Attach eight (8) screws (not included in the package) to secure the Corner Mount to the wall.

NOTE:

Purchase screws applicable to the wall type you are mounting the Corner Mount to.