ZeeVee ZvBox 180 - Manual (Page 5)

ZvBox ® 180 Get Going Guide Page 5
v.1.0
Configuring ZvBox ® 180
In most cases, ZvBox® 180 can be configured using the front panel buttons. Configuration is simple, and usually just
involves setting the RF channel on which the ZvBox® will broadcast. Settings are stored in ZvBox® and not lost on
power‐down.
An example for changing the RF broadcast channel is shown below.
Note – make sure the HDTV connected to your ZvBox® is set to Cable mode, vs. Antenna or Over‐the‐air mode.
ZvBox® broadcasts using QAM – the same standard used by cable companies.
1. Press the Next button until SET CHANNEL appears in the display
2. Press the + or – key until you see the channel number you want to use – for example 7 .
3. Press the OK button
That’s it! In this example, your ZvBox® would be broadcasting on RF channel 7, and would be tuned in at your HDTV by
entering
7.1 . Note – sometimes a channel scan is required at the HDTV before the new channel is recognized.
For information on customizing ZvBox® with alternative settings, go to http://zeevee.com/configuration and view or
download the ZvBox® 180 Configuration Manual.