ZeeVee ZvPro 600 Series (DVB-T/C) - Manual (Page 5)

ZvPro 600-EU Configuration Guide
|
Page 5
Beginning setup
1. Apply power.
2. Connect the cables according to your cable choice:
 HYDRA AV CABLE— Connect the Component (RED/GREEN/BLUE)
Video connectors on the A/V Cable to the corresponding
Video Outputs on your video source. Use the Composite
(YELLOW) connector for teletext. Connect either the Digital
(ORANGE) or Analog (RED/WHITE) Audio connectors on the A/V
Cable to the Audio Outputs on your video source. Connect
the DIN to the A/V Input on the ZvPro.
If you want to implement the delay matched audio feature,
you need to use analog audio.
 VGA/DIN CABLE— Connect the VGA connector to the
VGA Output on your video source. Use the Analog Audio
connector with the Audio Out on the Video Source. Connect
the DIN to the A/V Input on the ZvPro.
Tuning your channel at the HDTV (Auto Scan)
1. Connect the Coaxial Output of the ZvPro to your RF network.
If the RF power for your network is too high, you will
observe video breakup.
2. Set the RF Input on the TVs to
DVB-T (default) or DVB-C with
the Symbol Rate 6740 KS/sec.
3. Enter the RF number to tune
directly to the channel. (Refer
to Default Channel Lineup for
default information.)
If you cannot tune directly to
the channel at this point, it is
because most TVs will require you to run a full Auto Scan.
4. Run the Auto Scan through the menu system of your
HDTV to find the channels.
Basic Installation
Factory default settings allow ZvPro 600 series modulators to broadcast up to two sources on RF channels 21 and 22 for
reception at connected HDTVs.
We recommend using the most updated version of firmware. You can find the latest version on the Support section of our website.
Audio Out
Composite
Video Out
Component
OR Video Source
Component Video Source
Analog Digital
Video Source
VGA Video Source
Video Out Audio Out
Hydra AV Cable VGA DIN Cable
VGA Analog
Coax cable connects
to coax network
RF Output
+25 dBmV
Ethernet to network or
directly to computer
Optional Delay Matched
Audio Output (Analog)
to audio system
DEFAULT CHANNEL LINEUP
DVB-T Factory
Defaults Logical
Channel #
Ch. 21 (474 MHz) 1
Ch. 22 (482 MHz) 2
Optional DVB-C
Channel Plan Logical
Channel #
Frequency 85 MHz 1 2
fo
r
T
ele
tex
t
only