User’s manual – X-Treme Audio MISI User Manual
Page 14
24
XTMISI
Middle-Sized Line Array module - Power handling RMS: 900 W - Impedance (bi-amp) 8+8 Ohm - Max SPL: 136 dB
12
XTMISIS
Arrayable double subwoofer - Power handling RMS: 2400 W - Impedance: 4+4 Ohm - Max SPL: 140 dB
8
XTHPS21
“Big Punch” Infra-bass subwoofer - Power handling RMS: 1500 W - Impedance: 8 Ohm - Max SPL: 139 dB
20
XTDT6000F
Stereo Switching Class D Amplifier with PFC (95-265 VAC) - Output Power RMS: 4x1500 W (@4 Ohm)
2
XTDP26
Digital Speaker Management System - Ways: 2 Input, 6 Output - Frequency response: 12÷20k Hz ±0.5 dB
UNITS
= Utilized loudspeaker systems-power amplifiers connections.
1+
1-
2+
2-
3+
3-
4+
4-
NL8
LF+
(XTMISI)
LF-
(XTMISI)
Mid/Hi+
(XTMISI
bi-amp)
Mid/Hi-
(XTMISI
bi-amp)
High+
(XTMISI
tri-amp)
High-
(XTMISI
tri-amp)
NL8
SW+
(XTMISIS)
SW-
(XTMISIS)
NL4
SW+
(XTHPS21)
SW-
(XTHPS21)
Pins
Type
DSP UNIT
SOUND FILE
OUTPUT
OPTIONS
FUNCTION
XTDP26
12_XTMISI_Mono.dfa
Near/Far*
Array made of 12 bi-amplified elements
without subwoofer
12_XTMISI+XTMISIS+XTHPS21_Mono.dfa
---
Array made of 12 bi-amplified elements
with subwoofer
(*) The “Far” output has a boost in the ultra- high frequency zone; to be used for a set of upper modules which are positioned in the top part of the array (suspended or stacked), depending on installation
geometry and environmental conditions (architecture, humidity), to throw the very high frequencies far enough, despite air absorption.
The XTMISI and XTMISIS cabinets are fitted with a pair of Neu-
trik Speakon NL8 connectors, while XTHPS21 sub uses Neutrik
Speakon NL4. The double Speakon connector permits to connect
in parallel a further loudspeaker system of the same type. All eight
pins of both connectors are wired in parallel. The XTMISI uses the
pin assignments 2+/2- for woofer, 3+/3- for mid-high section in
bi-amp (this configuration) and 4+/4- for high section in tri-amp.
Pins 1+/1- are designed to XTMISIS and XTHPS21 subwoofers.
CONNECTORS
PROCESSOR PROGRAMS
ACCESSORIES
STD-MISI
Flying bar for Middle-Sized Line Array
XT-ANGLE
Electro-mechanical device for setting the pitch of the line array systems (flying bar not included)
XT-ANGLERC
Remote controller for XT-ANGLE with bright display (cable included, 10 m in length)
XT-D8P
Connection panel specially designed for line arrays
XT-PSB32/8
Patch board 32A - 2 XLR IN, 2 XLR OUT - 4 Speakon OUT NL8MPR - 3 rack units
XT-NETINT
Network Interface for XT-NET connection (PC adapter: from USB or RS232 to standard RJ45)
XT-NETPS
Power unit for supplying up to 2 XT-NETINT (if a RS232 is used)
XTMISIS-SK
Wheelboard for XTMISIS and XTMISIS/A double subwoofer
XTHPS21-SK
Wheelboard for XTHPS21 infra-bass subwoofer
14/21