Westermo TF-300 - Manual (Page 15)

15 6606-2201
Result codes
When a command is sent from the DTE the modem replies with a result code. The result
code may be either in Long Form i.e. text (V1) or in Short Form i.e. a digit code (V0).
The result code in Long Form is followed by and in Short Form by .
The result codes are enabled by using the Q1 command.
The possible result codes are as follows:
With basic response set (X0)
0
OK Command accepted and executed.
1 CONNECT A call has entered the connect phase.
2 RING Incoming call detected.
3 NO CARRIER Ended call (correct or incorrect) or no carrier.
4 ERROR Illegal command / command not possible
With extended response set (X1) as above and:
6
NO DIALTONE No carrier or error code DER from network
7 BUSY Error codes NC or OCC from network
8 NO ANSWER Error codes NA, NP, NCH or ABS from network