Westermo DR-270 - Manual (Page 10)

10 6622-2241 • 29000589, REV.A
Interface specifications
Power
Rated voltage
9 – 36 VDC
Operating voltage 9 – 36 VDC
Power consumption DR-270 – typical:
1.02 A = 12.24 W, max: 1.03 A = 12.36 W
DR-270 + WiFi – typical:
1.12 A = 13.44 W, max: 1.140 A = 13.68 W
DR-270 + 3G – typical:
1.23 A = 14.76 W, max: 1.24 A = 14.88 W
DR-270 + 3G + Wi-Fi – typical:
1.31 A = 15.72 W, max: 1.42 A = 17.04 W
Rated frequency DC
RS-232
Electrical specification
EIA RS-232
Data rate 300 bit/s – 115.2 kbit/s
Data format 7 or 8 data bits, Odd, even or none parity, 1 or 2 stop bits
Protocol Transparent, optimised by packing algorithm
Circuit type SELV
Transmission range 15 m / 49 ft
Connection 9 pin D-sub female
Shielded cable Not required
Conductive housing Yes
Number of ports 1
Ethernet TX
Electrical specification
IEEE std 802.3. 2005 Edition
Data rate 10 Mbit/s, 100 Mbit/s, manual or auto
Duplex Full or half, manual or auto
Circuit type SELV
Transmission range 100 m / 328 ft
Isolation to All other
Connection RJ-45 auto MDI/MDIX
Shielded cable Not required, except when installed in Railway applications as signalling
and telecommunications apparatus and located close to rails.*
Conductive housing Yes
Number of ports 4
* To minimise the risk of interference, a shielded cable is recommended when the cable is located inside 3 m
boundary to the rails and connected to this port.
The cable shield should be properly connected (360º) to an earthing point within 1 m from this port.
This earthing point should have a low impedance connection to the conductive enclosure of the apparatus
cabinet, or similar, where the unit is built-in. This conductive enclosure should be connected to the earthing
system of an installation and may be directly connected to the protective earth.