Westermo DDW-120 - Manual (Page 14)

14 6621-2214
Using a terminal program
If a customer supervision system is used the DDW-120 can provide with diagnostic
status.
The DDW-120 support
Data rate: 115.2 kbit/s
Data bits: 8
Stop bits: 1
Parity: None
Flow control: None
The unit is responing to two commandon
1) DIAG
2) RUNDIAG
Information from DIAG command
• Software release
• DIP switch settings
• If the unit is configured as CO or CPE
• If the unit is configured for Annex A or Annex B
• DSL link state
• DSL data rate (bit/s)
• DSL noise margin (dB)
• Ethetnet data rate
• Ethernet duplex
Information from RUNDIAG command
• DSL link state
• DSL Data rate (bit/s)
• DSL Noise margin (dB)
The DDW-120 is ready for commando then prompt “DDW” is transmitted to
supervisor system.
The commando RUNDIAG will continuously send the information. Approx update with
1s base. Commando is aborted by sending “any key to abort”.