Eureka 2280 - Manual (Page 13)

13
1. Remove the attachment hose from the lower hose
retainer and look into the hose retainer for any
obstructions. Proceed to Step 2 to check for any other
blockages.
4. Check for blockages in the brush roll area and remove
any obstructions found there. The base hose can be
cleared of any blockage by using a blunt instrument.
5. After the blockage is removed, replace the hood and
tighten the two hood screws (see Fig. 2). Raise the
handle to the upright position place the hose into the
lower hose retainer.
How to Check and Clear Blockages in Base
2. Lower handle to floor. Turn cleaner over so the bottom
of the power head is facing up. Remove two screws
to release hood.
3. Hold power head together and turn over with hood side
up. Lift hood up off of power head.
1
2
|
3
4