Electrolux MCC 663 - Manual (Page 6)

6
Connecting to the mains
• The oven is delivered with the power
cord and a plug for 230-240 V, 50Hz,
earthed socket outlet.
•
Earth protection minimizes the risks
should a short-circuit occur. Check to
ensure the voltage of the oven matches
the supply. N.B. If the oven is connected
to the socket via an extension cord,
make sure the cord is earthed.
This appliance must not be used on a
non-earth protected power supply.
Contact an electrician if you are
uncertain regarding electrical connection
of the oven or provision of earth
protection of the supply.
•
Microwave power output : 900W
•
This appliance complies with E.E.C.
directive No.87/308 of 2.6.87 relative to
radio interference suppression.
Information concerning UK installation
•
If this appliance is fitted with a non-
rewirable plug for which your socket is
un-suitable, the plug should be cut off
and the appropriate plug fitted. If it is
necessary to change the fuse in a
non re-wirable plug, the fuse cover must
be refitted. If the fuse cover is lost or
damaged, the plug must not be used
until a re-placement is obtained.
•
The plug moulded on to the lead
incorporates a fuse. For replacement,
use a 13 Amp BS1362 fuse. Only ASTA
or BSI approved fuses should be used.
•
The plug must not be used if the fuse
cover/carrier is lost. The cover/carrier is
indicated by the coloured insert at the
base of the plug. A replacement cover /
carrier is indicated by the coloured
insert at the base of the plug and must
be obtained from your local Electrolux
Service Centre.
IMPORTANT
•
The wires in the mains lead are coloured
in accordance with the following code:
GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
•
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
your plug, proceed as follows:
Connect the green and yellow (earth)
wire to the terminal in the plug which is
marked with the letter ‘E’or the earth
symbol ( ) or coloured green and
yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked with
the letter ‘N’or coloured black.
Connect the brown (live) wire to the
terminal in the plug which is marked with
the letter ‘L’ or coloured red.
13 AMP FUSE
BLUE
GREEN & YELLOW
BROWN
CORD
CLAMP