Vinpower Digital USBShark - Manual (Page 18)

15
8. Utilities
1) Device Info
This function will show information regarding the flash device connected to the
system.
2) System Info
This function will show the system’s hardware & software information.
3) Measure Speed
This function will scan any inserted flash device(s) (ex. USB, SD, CF, etc) in any
socket. The display will show the reported capacity and the Read/Write Speed of
the selected device.
4) Verify Source
This function will scan the original flash device for readability.
5) Rebuild Source
This function will rebuild the original flash device in case of high Compare failure.
6) Load Default
This function will reset all of the options back to the manufacture’s default
settings. Perform this function if the system is acting abnormal. Perform the
“Shutdown” operation and restart the system in order for these changes to take
effect.
7) Update Firmware
This function will update the software for the system. To update:
a. Copy the manufacture certified update file onto a USB Storage Device via
a PC/Mac.
b. Insert the USB Storage Device into the Source Port of the system.
c. Go to this function and execute it by pressing
the “ENT” button.
d. Restart the system when asked to do so.
It is strongly suggested that an upgrade to the system’s firmware not be
performed, unless the system is getting unstable and instructed to do so by a
technician.
8) Save
This function will save all the settings modified since the last time the system was
booted-up.