Verilink PRISM 3301 (CG) Configuration/Installation Guide - Manual (Page 2)

Set Net LBO: 0, 150, or 300
Yellow XBIT: 0 or 1
AIS
Pattern: Blue or FAO
RX-Stuffing: On or Off
DTE Rate: 3, 6, 12, 18, 25, 31, 37, or 44 TX-XBIT: 0 or 1
CA: LOS, OOF, RXAIS, or RXYELLOW
DSU: Primary or Secondary
Supervisory Mode: Modem or Direct
Baud: 1.2, 2.4, 4.8, 9.6, or 19.2 kbps
COA: On or Off
Dial String
Hangup String
Init String
Map M-Frame: 1 through 7
SLIP Mode: Direct or Modem
Baud: 1.2, 2.4, 4.8, 9.6, or 19.2 kbps
Dial String
Hangup String
Init String
Filter
1 through 4: IP Address
Unit Address
Subnet Mask
Router Address
SNMP Read Community
Write Community
Trap
1 through 6: IP Address
System
Scrambler On: 7 or 10
Off
Program: EPROM Administration Password Name/Level
TOD Delete
UnitID Change
Circuit
Application
Audible
Datalink EIC
LIC
FIC
UIC
Path-Message
Idle-Message
Test-Message
Terminal
DTE
Carrier
Get: Net, DTE, Audible, Supervisory, SLIP, SNMP, Map, Status, Scrambler, Program, Administration, Datalink, or Far-Datalink
Reset: Alarms, Config, or Performance
Query Alarms
Loop
Performance: ESF, ES, SES, or SFE
Test Loop Local DTE: Set or Clear
System Remote: Set, Clear, Request, or End Line: Set or Clear
Reboot: Cold or Warm
Command Line Menu Tree