Venstar T1050 - Manual (Page 6)

Press the MODE and FAN
buttons at the same time
for two seconds to enter
Setup screens.
Press the MODE
and FAN buttons
at the same time
t o r e t u r n t o
normal operation.
Quick Start Set the Clock and Go
The thermostat is preprogrammed from the factory to operate
one or two stage equipment* without the need for further
programming. To optimize the installation of this thermostat,
follow the instructions in the Advanced Setup section.
* The thermostat is not preprogrammed from the factory to operate
electric heat or heat pump systems. To control these systems,
follow the steps in the Advanced Setup section, pages 11 & 12.
Press
MODE
Setting the Clock
Setting the Day
Am
Setup
I2:00
Setup Mo
During Setup & Programming:
Pressing the UP or DOWN
butt ons will modify th e
flashing selection.
To adjust the
Clock or Day use
Tip: To change hours quickly,
press and hold the FAN
button and press the UP or
DOWN buttons.
buttons.
MODE FAN
MODE FAN
Page 5