Ultimate-sound Movie System - Manual (Page 3)

STEP 2
Wiring the speakers
Note: Please turn off your system prior
to making any connections.
To wire your system, please use good quality,
speaker grade audio cable with polarity
coding (usually identified with a marking on
the cable) as per the gaugerecommendations
indicated below. The side of the cable that
has the coding (a ridge, or "+" marking)
usually denotes the positive polarity.
Connect the positive lead of the speaker wire (indicated with a "+" or other
marking) to the Red (or positive) speaker terminal. Connect the other speaker
wire lead to the Black (or negative) speaker terminal. Connect the opposite end
of the speaker wire to your amplifier making sure that the polarity is preserved
("+" to "+" or Red to Red, and "-" to "-" or Black to Black – see diagram).
STEP 3
Listening Test
Once you have connected your
speakers, turn on your system and
begin playback of material you are
familiar with. Begin at low volume and
increase to a comfortable listening
level. The system should sound
balanced with good stereo imaging. If
the imaging sounds distorted and
confused, check to make sure that the
speakers have been correctly wired
with your amplifier/receiver as
indicated in Step 2.
Maintenance
Your Ultimate loudspeaker cabinets
are finished with a high quality vinyl
that requires very little maintenance.
Simply use a damp cloth to remove
dust and fingerprints, and avoid all use
of chemical products and polishes on
the cabinet and grille.