TS Performance 6150100 - Manual (Page 2)

Continued
Contents
(1) 10lb. Nitrous Bottle Bottle Brackets
(3) Solenoids (1) Control Box
(1) Pre-Made Wire Harness (2) Nitrous Jets
(2) 1/8
”
Nozzles 10ft #3 Line
14ft #6 Line (2) #3 Straight AN fittings
(2) #3 90 degree AN fittings (1) #6 Bottle Nut Adapter
(1) Nitrous Gauge
(1) 1/8” 27 NPT tap
(1) WOT Switch
Installation Instructions
Read and fully understand all instructions before attempting to install the
TS Performance PowerFool 2 Nitrous Kit
Note: Nitrous is a Power additive and should be used only for race purposes this is not intended for street
use. For off road use only.
1. Disconnect batteries and remove keys from ignition.
2. Decide where you would like to mount your Command Center. (The Command center is a black
box with 3 switches. The switch to the left is the On/Off switch. The middle switch is the Purge
button and the right switch is the 2
nd Stage button.) We recommend an area that is accessible and
with-in reach while driving the vehicle.
3. Mount the solenoid box in the engine compartment. Make sure the box is mounted flat and away
from moving objects.
4. Route the purple, blue and orange wires with pre-terminated pins through the firewall to the
engine compartment. They will be in wire sleaving with a 12 gauge red wire.
5. Use the supplied weather-pac connector and attach it to the wires coming through the firewall. It
should have a black wire with an eyelet on the other end. (The eyelet should be connected to a
constant ground.) Insert the purple wire into location A, the blue wire into location B and the