TS Performance 5130100 - Manual (Page 2)

Continued
TSMPDw/MP-DHU
Operation of MP-D Monitor
Using the Monitor
1. Before driving the truck you will need go to the setup menu and select the proper vehicle file.
2. To access the set-up menu press the right button.
3. Then Choose select vehicle and select your application
4. Use the up and down buttons to scroll through the menu.
5. Use the right button to go to next menu and to select item
6. Use the left button to go back to the previous menu.
7. Once the vehicle has been selected you will need to set the “Disp. Brightness” and the “HU
Brightness”
8. Next you will need to set the “Alarms”. This is to be used to set the minimum or maximum in each
gauge that way an alarm will sound if you exceed the set amount.
9. Now set the Heads-Up Display how you want it by selecting “Invert HUD”. With it set as Heads-Up
mode it will shine onto the windshield. If you choose to invert the Heads-up it can be pointed toward
the driver.
10. From Main menu shown below use the left button to see the min and max values logged form last time
started. If shut off will loose min and max values stored in monitor
11. From Main menu use the Up and Down button to scroll through the four readings to change what is
projected on the heads-up display
Harness Goes to Left as Shown