TS Performance 1190101 - Manual (Page 2)

Continued
Installation:
1) Use supplied pink connector, crimp to RED wire on ReSpeed; crimp supplied eyelet to BLACK
wire.
2) Use the supplied T-tap and tap RED wire into KEY ON +12 V usually located under the dash.
3) Connect the black wire to good clean ground.
4) Put the other T-tap on black wire to add speed limiter switch later (Figure 1).
Speed Sensor Hook-up
5) The speed signal wires are usually
twisted together and sometimes
wrapped in black tape unless coming
from the ABS or PCM. One of these
wires is sensor ground and the other
carries the signal. Refer to Chart D to
locate you speed signal wire. Cut the
speed signal wire.
6) Using supplied blue butt connectors,
connect the Respeeds Green wire to the
cut wire coming from sensor. The
green wire is the Respeed input and the
white wire is the output.
7) Connect the Respeeds white wire to the
wire going to PCM also using the
supplied blue butt connectors.
Speed Limiter Switch
The speed limiter switch turns the speed limiter
on the vehicle on or off. Pushing the switch
allows the ReSpeed module to see ground and
disable the speed limiter.
a. Mount the switch in an
accessible area (Figure 2).
b. Connect purple wire from
Respeed to one side of the
switch using a blue connector.
c. Connect supplied wire to the
other side of switch using a
blue connector. Then run the
other side of supplied wire to
ground using pink connector
(Figure 4).
d. Connect the pink connector to
the red T-tap applied to ground
wire earlier in instructions.
(Figure 4).
Figure 1
Figure 2
Figure 3
Figure 4