TS Performance 1100300 - Manual (Page 2)

Continued
Installation of the TS Performance MVP Tuner
Read all instructions and fully understand them before installing you TS Performance MVP module.
Disconnect the battery terminals and remove keys from ignition before installation.
1. Find a proper location for mounting the module. We recommend the Fuse and
Relay Center on the driver’s side of the engine compartment in front of the
battery. Use the supplied velcro to fasten the module to the fuse box.
2. Locate the MAP Sensor just behind the fuel filter on the driver’s side of the
engine. Disconnect the factory plug and connect our harness in-line with the
supplied connectors.
3. Locate the CAN connector in the engine harness on the driver-side of engine.
The CAN connector can be found anywhere from the front to the rear of the
engine. It will either be a 3-pin Packard Weather Pack connector or a 3-pin
triangle deutsch connector; this connector should have a false plug in it. Unplug
the false plug and plug our CAN connector in.
4. Route the adjustable switch wire through the firewall to the MVP module.
5. Mount the switch on the dash in reach f the driver.
6. Re-connect the battery terminals
Using your TS Performance MVP module
The switch provided is adjustable from stock up to 100 horsepower. As you turn the
switch clockwise, power will increase. For best fuel economy turn the switch at least ¾’s
of a turn to all the way up.