TS Performance 2110402 - Manual (Page 3)

Continued
3. Locate the MAP Sensor. The connector will be a three pin connector as seen in the picture. Use
the supplied connectors and plug into the MAP Sensor and factory harness.
4. The MAP sensor will be located on the intake manifold tube coming into the engine out of the
intercooler.
Now you will need to locate the Fuel Pressure Sensor. The
connections will look like the connectors pictured above.
5. On the LLY engine the Fuel Pressure Sensor is located
under the air intake tube on the passenger’s side of the
engine as pictured above. Disconnect the connections
and plug our module in line.
6. Now you need to decide where you want to mount your
adjustable switch. We suggest using the area just to the
left of the airbag shut-off switch. If you do not want to
drill your dash you can also hang the switch beside the
steering column.
If there are any questions on the product or installation of the module give us a call at TS Performance
(270) 746-9999
LLY Fuel Rail Pressure Sensor