TS Performance 2110203 - Manual (Page 2)

Continued
Installation of TS Performance Power Play MP-8
2006 Caterpillar C-7
Read all instructions and fully understand them before installing your TS Performance MP-8
module. Disconnect the battery terminals and remove keys from the ignition before installation.
Place Di-Electric Grease onto every electrical connection.
1. Locate a place to mount the MP-8 module inside the engine compartment on the driver’s side
where it will be free from extreme heat and moisture. Use the supplied zip ties to securely mount
the module.
2. Locate the MAP Sensor towards the back side of the engine on the driver’s side, next to the valve
cover. Unplug the factory harness from this sensor, it will have a red lock as shown and pink,
white, and green wires, and plug the harness from the MP-8 with the red locks into sensor and
factory harness.
3. Locate the ICP sensor located toward the front of the engine on the same side as the MAP sensor.
It will be next to the valve cover going into the head. Unplug the factory harness from the ICP
Sensor, it will have a grey lock and have brown, green, and white wires, and then plug the MP-8
harness with the grey locks into sensor and factory harness.
4. From the inside of the cab, route the wire from the adjustable switch through the firewall to the
module in the engine compartment.
5. Mount the switch in the dash in a location the driver can easily access.
If there are any questions on the product or installation of the module give us a call at
TS Performance (270) 746-9999