TS Performance 2110103 - Manual (Page 2)

Continued
Installation of TS Performance Power Play MP-8
International DT444
Read all instructions and fully understand them before installing your TS Performance MP-8
module. Disconnect the battery terminals and remove keys from the ignition before installation.
Place Di-Electric Grease onto every electrical connection.
1. Locate a place to mount the MP-8 module inside the engine compartment on the
driver’s side where it will be free from extreme heat and moisture. Use the
supplied zip-ties to securely mount the module.
2. Locate the Fuel Pressure Sensor on the driver’s side of the engine block toward
the front. The Fuel Pressure Sensor is under the tube running from the intercooler
back to the engine.
3. Route the wire from the adjustable switch through the firewall to the module.
4. Mount the switch in the dash in a location the driver can access easily.
If there are any questions on the product or installation of the module give us a call at
TS Performance (270) 746-9999
TSP01DT Harness