TS Performance 4111002 User Manual
Page 6
Continued
3. Locate the ICP sensor directly in front of the MAP Sensor toward the front of the engine. The ICP
connector on the engine usually has white, green, and brown wires. Unplug the factory harness
from the ICP Sensor and plug the MP-8 harness into it which has the white and blue wires.
4. From the inside of the cab, route the wire from the adjustable switch through the firewall to the
module in the engine compartment.
5. Mount the switch in the dash in a location the driver can easily access.
HP increase of 30%
Decrease Fuel Consumption by up to 15%
On-The-Fly Adjustable
When removed leaves to trace of modification or foot prints
Power increases as you turn the switch clockwise 0-30% over stock
If there are any questions on the product or installation of the module give us a call at TS Performance
(270) 746-9999