TS Performance 4110402 - Manual (Page 2)

Continued
Instructions for installation
Place Di-Electric Grease onto every electrical connection.
1. Locate the fuel injection rail. It will be located on
the side of the engine with six steel lines that run to
the injectors.
2. Now locate the fuel pressure sensor, number 10 on
the schematic to the right. This will be found on the
rail and will be the only connector that looks the
same as the MP-8 harness.
3. Unplug the sensor; plug the connector from the
MP8 harness in to the sensor.
4. Now plug the factory harness in to the left over
connector.
5. The MP8 comes with two 14” zip ties to mount the
box in a dry cool location.
6. Route the cables away from any moving parts or
places that might damage the cable with the 4” zip
ties supplied.
7. The switch may be mounted in the cab or under the
hood.
DO NOT unplug the MP8 Module while the engine is running. This may result in
engine or component failure and may void warranty on the engine or MP8 unit.
If you have any questions contact TS Performance @ 270-746-9999