Instructions for installation – TS Performance 4110201 User Manual
Page 2
Continued
Instructions for installation
Place Di-Electric Grease onto every electrical connection.
1. Locate the fuel injection rail. It will be located on
the side of the engine with six steel lines that run to
the injectors.
2. Now locate the fuel pressure sensor. This will be
found on the rail and will be the only connector that
looks the same as the MP-8 harness. It is identified
as #10 in the diagram to the right.
3. Unplug the sensor; plug the connector from the
MP8 harness in to the sensor.
4. Now plug the factory harness in to the left over
connector.
5. The MP8 comes with two 14” zip ties to mount the
box in a dry cool place.
6. Route the cables away from any moving parts or
places that might damage the cable with the 4” zip ties supplied.
7. The switch may be mounted in the cab or under the hood.
DO NOT unplug the MP8 Module while the engine is running. This may result in
engine or component failure and may void warranty on the engine or MP8 unit.
If you have any questions contact TS Performance @ 270-746-9999