Demco TP20094 User Manual
Page 3
2.
Attach right and left mounting bracket
with two previously existing bolts on
each side.
3.
Install cross member with three 3/8" x 1-
1/4" hex bolts, lockwashers and hex
nuts on each side.
4.
Install center support brace by taking
two bolts out of vehicles center brace.
(NOTE: Be sure to leave in the third
bolt, only remove two bolts.)
Attach
center support to vehicle using two
10mm x 1.25 x 30mm bolts and 10mm
lockwashers. Snug tighten these bolts
and secure front of support using two
3/8" x 1-1/4" hex bolts, lockwashers,
flatwashers and hex nuts. Push cross
member up and tighten all bolts.
NOTE: Center support brace
goes on top of baseplate center
bracket.