Tri Tool 204B Beveler - Manual (Page 21)

21
Model 204B BEVELMASTER™
92-0699 : Rev. 060412
To avoid tool bit damage, the feed rate should be very slow until the tool bit(s) is in
contact with the pipe continually during at least one full revolution.
Continue rotating the feed handle clockwise until the end of the pipe is completely
machined.
Discontinue feed and allow the head to rotate one (1) to three (3) revolutions to
improve finish of the prep surface.
Release the air motor trigger to stop the head rotation.
Rotate the feed handle counterclockwise to separate the tool bit(s) from the pipe.
Rotate the feed handle counterclockwise until the tool bit to pipe relationship is the
same as described.
Loosen the draw nut on the mandrel to release the mandrel from the pipe.
The mandrel assembly may be left in the Model 204B BEVELMASTER™ and
installed as a complete assembly.