Tri Tool 201BA Electric Motor Assembly 110V - Manual (Page 5)

5
Model 201BA E Motor Assembly (110V)
92-0860 : Rev. 110829
Disconnect the power supply during setup and maintenance. Use all 'Stop' or 'Shut
off' features available when changing or adjusting tool bits, maintaining the tool, or
when the tool is not in use.
Remove adjusting keys and wrenches before applying power to the equipment.
Develop a habit of checking the tool before turning it on to make sure that all keys
and wrenches have been removed.
Do not force tools. Tools and tool bits function better and safer when used at the
feed and speed rate for which they were designed.
Do not reach into rotating equipment. Do not reach into the rotating head stock to
clear chips, to make adjustments, or to check surface finish. A machine designed
to cut steel will not stop for a hand or an arm.
Handle chips with care. Chips have very sharp edges and are hot. Do not try to pull
chips apart with your hands; they are very tough.
Avoid unintentional starts. Do not carry or handle tools with your hand on the oper-
ating switches or levers. Do not lay the tool down in a manner that will start the
drive. Do not allow the tool to flip around or move when adjusting or changing tool
bits.
Store idle tools properly. Disconnect tools from the power source and store in a
safe place. Remove tool bits for safe handling of the tool.