DirecTV DRD303RA - Manual (Page 40)

Connections
38
Connecting Your DSS ® Receiver to
Your TV
If your DSS ® system has not been professionally installed, or if
you move your system or add a component, refer to these pages
to help you connect your system.
Jacks and Cables
S-Video Jack and Cable (S-VHS)
The S-Video jack provides the best picture quality for your DSS ®
system.
This jack is available on many TVs and is used in conjunction with
audio cables to connect the DSS
® receiver to your TV. Remember
also to connect the left and right audio cables because the S-
Video jack carries only the picture signal, not the sound.
Audio/Video Jacks and Cables (RCA-type)
The audio/video jacks provide very good picture and stereo
sound quality, and should be used if your TV has no S-Video jack.
Theses jacks are used for most audio/video connections between
components. The DSS
® receiver audio/video jacks are color coded
(yellow for video, red for right audio, and white for left audio). If
your TV has only one input for audio (mono), connect it to the
right (red) audio jack on the DSS
® receiver.
RF Jacks and Coaxial Cables (F-type)
The RF jacks provide good picture and mono sound quality, and
are to be used if audio/video connections are not available for
your TV.
These jacks are required for antenna or cable-TV connections.
The RF jacks on the DSS
® receiver are labeled IN FROM ANT and
OUT TO TV. The coaxial cable supplied with your DSS ® system is
used to connect the RF jacks between the DSS ® receiver and your
TV’s antenna input.
Audio/Video Jack
S-Video Jack
RF Jack