Dolby Laboratories PVS177SG - Manual (Page 15)

GB - 14
PLAYING A DISC
This owner’s manual explains the basic instructions of this unit. Some DVD discs are produced
in a manner that allows specific or limited operation during playback. As such, the unit may not
respond to all operating commands. This is not a defect in the unit. Refer to the instruction notes
of discs.
“ ” may appear on the screen during operation. A “ ” means that the desired operation
is not permitted by the unit or disc.
Basic playback
Playing a Disc
1. Slide the POWER ON/OFF button on the left side of unit into on mode.
2. Slide the FUNCTION button on the right side of unit to select DVD mode.
See CUSTOMIZING THE FUNCTION SETTINGS to step 3.
3. Press the OPEN button to open the disc door.
4. Hold the disc by its sides and carefully make it fit onto the central support of compartment with the label side
facing up until you hear a “click”.
5. Close the disc door.
It takes a short while for your unit to load the disc. After loading, for some discs, the unit will automatically start
playback of the disc.
6. Press the PLAY button.
DVD CD
Pausing playback (still mode)
Press the II PAUSE button. To resume normal playback, press the PLAY button.
Stopping playback
Press the STOP button at the location where you want to interrupt playback. To resume playback at the position
where the disc was stopped, press the PLAY button.
If you press the STOP button twice, the unit’s memory will be cleared and pressing the PLAY button will reset
the disc to the beginning.
To skip to a different track
• Press the PREV button repeatedly to skip to the start of the current or previous track.
• Press the NEXT button to skip to the next track.
• For audio CD disc, use the number buttons (remote control only) to jump straight to that track number.
(continued to next page) (continued to next page) (continued to next page) (continued to next page) (continued to next page)