DeVillbiss Air Power Company 2225CWH - Manual (Page 11)

11 — ENG
OPERATION
BEFORE STARTING
1. Move pressure washer to level ground.
2. Check engine oil level. Refer to engine
manufacturer's manual for procedure.
NOTE
The engine on this pressure washer is
equipped with a low oil sensor. The
amount of oil in the engine must be correct
or the engine will not start.
3. Verify that filter screen is in water inlet of pump, as
shown.
4. Connect water supply hose to water inlet of pump
as shown.
NOTE
The water supply must provide a minimum
of 5 gallons per minute at 20 PSI.
NOTE
Use cold water only.
Never pull water supply hose to move
pressure washer. This could damage hose
and/or pump inlet.
5. Attach threaded end of high pressure hose to
spray gun as shown. Tighten securely with an
adjustable wrench.
screen
filter
6. Attach other end of high pressure hose to quick
connect fitting on pump as shown.
7. Make sure high pressure hose and water supply
hose are securely connected to pump.
8. If you are applying a chemical or cleaning solution
see How To Siphon Chemicals/Cleaning Sol-
vents in this section.
9. Turn water supply on.
Never turn water supply off while pressure
washer engine is running or damage to
pump will result.
10. Add fresh, unleaded regular gasoline to engine fuel
tank.
NEVER FILL FUEL TANK INDOORS. NEVER
FILL FUEL TANK WHEN ENGINE IS RUNNING
OR HOT. DO NOT SMOKE WHEN FILLING
FUEL TANK.
Water
Supply
Hose
High
Pressure
Hose