Studio Technologies 761 - Manual (Page 34)

Issue 1, March 2008 Model 761/771 User Guide
Page 34 Studio Technologies, Inc.
for Surround
dot in the lower-right corner is not lit the
current dialnorm level value is causing a
level adjustment to take place. This level
adjustment can be taking place in the
StudioComm system, if the dialnorm
enable function is active, as well as in
downstream users of the broadcast signal.
Note that if a valid dialnorm source is not
available the 4-digit display, when selected
to display dialnorm, will show four horizon-
tal bars. This could be due to a problem
with the metadata signal connected to the
Model 761 Central Controller. But more fre-
quently this will simply be the normal result
that occurs when the Model 771’s input is
not selected for HD primary.
Remote Control Inputs
Two remote control signals can be con-
nected to the StudioComm system and
confi gured for operation. The two func-
tions are remote mute all and remote dim.
When an external signal activates remote
mute all the LED on the Model 771 associ-
ated with mute all will fl ash. If mute all was
already active when the remote mute all
function is activated, the LED will change
from being steadily lit to fl ashing.
Figure 8. Incoming dialnorm level match “dot”
When an external signal activates remote
dim the LED on the Model 771 associ-
ated with the dim function will fl ash. If dim
was already active when remote dim is
activated, the LED will change from being
steadily lit to fl ashing.