Specifications – Studio Technologies 80 1999 User Manual
Page 16

Issue 5, October 1999
Model 80 User Guide
Page 16
Studio Technologies, Inc.
Specifications
Audio Input: 1, stereo (separate left and right
input connectors)
Loop Through: hardwired in parallel with input
(separate left and right loop-through connectors)
Type: electronically balanced, direct coupled
Input Compatibility: can be connected to
balanced or unbalanced signals
Impedance: 24k ohms
Nominal Input Level: 10 to +10dBu
Input Level Control: allows calibration over 10
to +10dBu input range
Right Trim Control: allows adjustment of right
input level over a 3dB range, nominal
Maximum Input Level: +27dBu balanced,
+21dBu unbalanced
Common Mode Rejection: 90dB @ DC and
60Hz, 85dB @ 20kHz, 60dB @ 400kHz (typical)
Audio Outputs: 8, stereo (separate left and right
output connectors)
Type: electronically balanced, direct coupled,
intended to drive loads of 600 ohms or greater,
can be connected balanced or unbalanced
Nominal Output Level: 10dBu (245mV) or
+4dBu (1.228V), each output individually switch
configurable
Maximum Output LevelBalanced: +27dBu
into 10k ohms, +26dBu into 600 ohms
Maximum Output LevelUnalanced: +21dBu
into 10k ohms, +20dBu into 600 ohms
Output Impedance: 50 ohms
Frequency Response: 10Hz-70kHz +0/0.5dB
(down 1dB @ 110kHz)
Distortion (THD+N): 0.004% (measured at
+4dBu input, +4dBu output, 20Hz-20kHz)
S/N Ratio: 91dB (20Hz-20kHz, ref. +4dBu)
Crosstalk: 75dB (1kHz, ref. +4dBu)
LED Indicators: 5, 1 power present, 4 input level
calibration
Fusing: 1
Type: 5 x 20mm time lag (Littelfuse 218-series or
equivalent)
Rating: 0.400A for 100 and 120V mains power,
0.200A for 220/240V mains power
Connectors:
Audio: dual, ¼-inch, 3-conductor phone jacks,
gold-plated contacts. (Manufactured by Neutrik)
Mates with all plugs specified by EIA RS-453.
AC Mains: standard 3-blade plug, meets IEC 320
specifications
AC Mains Requirement:
100, 120, or 220/240V, ±10%, factory configured,
50/60Hz, 100-120V 0.4A maximum, 220/240V
0.2A maximum
Dimensions (Overall):
19.00 inches wide (48.3cm)
1.72 inches high (4.4cm)
6.65 inches deep (16.9cm)
(1 standard rack space)
Weight:
7.0 pounds (3.2kg)
Specifications and information contained in this
User Guide subject to change without notice.