beautypg.com

Appendices, Appendix a – Studio Technologies Mic-Pre User Manual

Page 14

background image

Issue 5, April 1994

Mic-PreEminence User Guide

Page 16

Studio Technologies, Inc.

Appendices

Appendix A

Specifications

Mounting
One space in a standard 19-inch (48.3cm) rack

AC Mains Requirements
115Vac or 230Vac,

±

10%, switch selectable,

50/60Hz, 10 watts

Fuse
0.5A 115V, 0.25A 230V; units shipped to North
America use 3AG type, units shipped outside North
America use 5x20mm type

Number of Preamplifier Channels
2

Connectors
Microphone Inputs: XLR-type female, pin 2 high

Balanced Outputs: XLR-type male, pin 2 high

Unbalanced Outputs: ¼-inch, 2-conductor phone
jack

AC Mains: standard 3-blade plug, meets IEC 320
specifications

Microphone Inputs Type
Electronically balanced, capacitor coupled

Phantom Power
48

±

0.1Vdc, current limited via 6.81k ohm feed

resistors, on/off individually switchable for each
channel

Input Impedance
7.8k ohms

Noise
–69.5dB at 60dB Gain (i.e. –129.5dB EIN, which is
one dB above theoretical minimum) –103dB at 30dB
Gain (20Hz to 20kHz bandwidth, 150 ohm resistor
on input)

Frequency Response
+0/–1.5dB, 20Hz to 60kHz, 40dB Gain
+0/–0.5dB, 10Hz to 90kHz, 68dB Gain

Gain Range
+12 to +68dB, related to balanced output

Slew Rate
20V/usec

Distortion (THD)
0.0020%, 20Hz to 20kHz, 30dB Gain

Input to Output Phase Shift
9 degrees maximum, 20Hz to 20kHz

Input Common Mode Rejection
70dB, 20Hz to 20kHz, 30dB Gain

Balanced Outputs Type
Electronically balanced

Output Impedance: approximately 100 ohms

Output Level at Clipping (0dBu=0.7746V):
+30dBu into 10k ohms Balanced
+29dBu into 600 ohms Balanced

Unbalanced Outputs Type
Electronic

Nominal Output Level (0dBv=1V): –10dBv (techni-
cally the unbalanced output is set to be 11.8dBu
below the nominal balanced output of +4dBu)

Output Impedance: approximately 200 ohms

Output Level at Clipping (0dBv=1V): 16dBv into
10k ohms

Intended Load to Unbalanced Output: the
unbalanced outputs are intended to be connected
to loads of 10k ohms or greater

Dimensions (Overall)
19.00 inches wide (48.3cm)
1.75 inches high (4.5cm)
7.00 inches deep (17.78cm)

Weight
4.2 pounds (1.9kg)

Specifications and information contained in this user
guide subject to change without notice.