Studio Technologies 5202 - Manual (Page 9)

Model 5202 User Guide Issue 1, August 2014
Studio Technologies, Inc. Page 9
Model 5202
Dante to Phones and Line Output Interface
Specifications
Network Audio Technology:
Type: Dante Audio-over-Ethernet
Bit Depth: up to 24
Sample Rates: 44.1, 48, 88.2, and 96 kHz
Network Interface:
Type: twisted-pair Ethernet with Power-over-
Ethernet (PoE)
Data Rate: 100 Mb/s (10 Mb/s Ethernet not
supported)
Power: Power-over-Ethernet (PoE) per IEEE
802.3af class 1 (very low power,
≤3.84 watts)
General Audio Parameters:
Frequency Response: 20 Hz to 20 kHz, ±0.5 dB,
Dante to line output
Distortion (THD+N): 0.01%, measured at 1 kHz,
+4 dBu, Dante to line output
Dynamic Range: >100 dB, A-weighted, Dante to
line output
Headphone Output:
Type: stereo, configured to drive headphones
through 100 ohm series resistors
Compatibility: intended for connection to head-
phones with impedance of 100 ohms or greater
Level: adjustable using rotary level control
Maximum Voltage: 8 Vpp, 100 ohm load
Line Outputs: 2
Type: electronically balanced, capacitor-coupled,
intended to drive balanced or unbalanced loads of
2 k ohms or greater
Source Impedance: 200 ohms
Nominal Level: adjustable using rotary level control,
+4 dBu @ 100% rotation
Maximum Level: +24 dBu into 2 k ohms
Meters: 2
Function: displays level of Dante input signals
Type: 7-segment LED, modified VU ballistics
Connectors:
Ethernet: Neutrik etherCON RJ45
Headphone Output: 3.5 mm and ¼-inch
3-conductor jacks
Line Outputs: 3-pin male XLR
Dimensions (Overall):
4.2 inches wide (10.7 cm)
1.7 inches high (4.3 cm)
5.1 inches deep (13.0 cm)
Mounting Option: bracket kit
Weight: 0.8 pounds (0.35 kg)
Specifications subject to change without notice.