Smithco TCV 5000 Turf Truck (sn DT310022 – Current) Operator Manual - Manual (Page 13)

11
Service
Maintenance Service Interval Maintenance Procedure
Torque the wheel lug nuts. (64-74 ft/lb (87-100 Nm))
Change the engine oil and filter.
After the first 20 operating hours Replace hydraulic filter
Check the engine oil.
Check the hydraulic fluid level.
Check the tire pressure.
Check condition of hydraulic hoses and fittings.
Inspect and clean the machine.
Inspect cooling system.
Check the battery fluid level and cable connections.
Change hydraulic filter
Check engine for leaks or loose parts.
Check air cleaner.
Check tire pressure (20 psi front (30 psi) rear).
Torque the wheel lug nuts. (64-74 ft/lb (87-100 Nm))
Grease Machine.
Check Planetary for oil.
Check belt tension (where needed)
Ceck radiator hoses.
Change the engine oil and filter.
Change oil filter
Change hydraulic filter
Clean battery terminals
Every 400 hours Replace Fuel Filter
Lubricate machine
Visual inspection of machine and hydraulic hoses
Change oil.
Torque lug nuts.
Check battery terminals and electrolyte level.
Change all filters.
Every 500 hours or yearly
Every 100 hours
Every 200 Hours
After the first 50 operating hours
Before each use daily
SERVICE CHART
Before servicing or making adjustments to the machine, stop engine, block wheels and
remove key from ignition.
Follow all procedures and ONLY use parts prescribed by the manufacturer. Read the engine
manual before maintenance.
The suggested maintenance checklist is not offered as a replacement for the manufacturer’s engine manual but
as a supplement. You must adhere to the guidelines established by the manufacturer for warranty coverage. In
adverse conditions such as dirt, mud or extreme temperatures, maintenance should be more frequent.