Smithco Big Vac V72E Operator Manual (2010) - Manual (Page 10)

8
Introduction
CONTROLS & INSTRUMENTS
A. Oil Light - The oil light should come on when ignition is on without engine running. The oil light will
light when the oil pressure is low. If oil light should come on, shut off engine immediately and find the
cause.
B. Hour Meter - The hour meter indicates hours of machine operation. The hour meter operates when
ignition switch is on.
C. Tailgate Lever - The tailgate lever is used to open and close the tailgate. Refer to decal for direction.
D. Reel Off-On Valve - Turns the reel on or off. Refer to decal for direction.
E. Ignition Switch - The ignition switch has three positions: Off - Run - Start.
F. Hand Throttle - The hand throttle is used to regulate engine speed.
G. Reel Lift Lever - The reel lift lever is used to raise and lower the reel. Refer to decal for direction.
(Optional)
HOPPER LIFT SAFETY
The Hopper Lift Safety is used to support the
ram on the hopper bottom in the extended
position so you may service or repair the
machine under the hopper. When not in use
the Hopper Lift Safety can be stored on the
hopper bed frame.