DeLonghi PAC W130E - Manual (Page 6)

6
A
IR
-
CONDITIONING WITH INSTALLATION
If required, your appliance can also be installed semi-perma-
nently (Fig. 7).
Proceed as follows:
• Drill a 4.17 inche (106 mm) diameter hole respecting the
heights shown in fig. 8 and following the indications in figs. 9,
10 and 11.
11.8 in
30 cm
11.8 in
30 cm
7
10
MAX 39 in
MAX100 cm
MIN 14 in
MIN 35 cm
8
106 4.17 in
9
In the window pane.
In the wooden kickboard
of a French window.
11
In the wall: it is
recommended that you
insulate the section of
the wall using suitable
insulation.
• Fit the wall flange (S) into the hole.
• Fit the air exhaust hose (K) in the housing at the back of the
appliance (fig. 1).
• Fit the end of the air exhaust hose to the wall flange as shown
in fig. 8. When the air exhaust hose is not fitted, the hole can
be closed with the flange cap.
Keep the air hose as short and free of curves as possible to avoid
bottlenecks.
When installing the air conditioner semi-permanently, you
should leave a door slightly open as little as 1/2“ (1cm) to gua-
rantee correct ventilation.
✔