Smithco Line Star 44-508 (Sn LN666) Operator Manual - Manual (Page 14)

11. To drain tank, open drain valve on manifold.
tank unless pressure is released from
tank by opening valve “C”.
marking liquid in tank, it can be done as follows:
If this is not done, paint can be drawn into the
.
ve “C” is closed.
. Air will enter tank at the top to agitate marking liquid.
. Valve “C” must be closed.
12
WARNING: Do not remove cap from the
AGITATING INSTRUCTIONS (SEE FIG. VI)
If desired to mix the
1. Close valve “A”.
2. Open valve “B”.
NOTE: To keep paint from going down the CO2 Regulator line, be sure to open
valve “A” when agitating is done.
CO2 Regulator, causing damage
3. Make sure val
4. Start engine.
5
TO USE HAND GUN
1. Valve “A” must be open.
2. Valve “B” must be closed.
3
MAINTENANCE INSTRUCTIONS