Smithco Supreme 35-000-A Operator Manual - Manual (Page 10)

8
Introduction
OPERATION AND DAILY CHECK LIST
STARTING ENGINE
Before operating this machine, become familiar with all controls and functions of this units. Also complete all
maintenance requirements and read all safety warnings. By knowing the
machine thoroughly, how it operates and by doing the prescribed mainte-
nance steps, you can expect relatively trouble-free operation for years to
come.
1. Make sure the fuel flow valve, located on the fuel tank, is “ON.”
2. Set park brake. Start safety switch is on the park brake.
3. The ignition switch is a three position. Insert key (A) and turn
clockwise until engine starts (C). Release key and it will return to
run position (B). Use choke and hand throttle as necessary.
4. Allow engine to idle and warm up a few minutes before selecting a
direction of travel.
5. To shut off engine turn key to the stop position.
DAILY CHECKLIST
Use all procedures and parts prescribed by the manufacturer's. Read the engine manual
before operation.
The suggested maintenance checklist is not offered as a replacement for the manufacturer’s but as a supple-
ment. You must adhere to guidelines established by manufacturer for warranty coverage. In adverse conditions
such as dirt, mud or extreme temperatures, maintenance should be more frequent.
DAILY CHECKLIST
1. Check park brake adjustment. Adjust as required.
2. Check engine oil level. Add as needed. DO NOT OVERFILL.
3. Tire pressure should be 5 psi (0.35bar) maximum.
4. Inspect electrical system for loose connections or frayed wiring, including battery cables. Replace any
faulty equipment or tighten if loose.
5. Check hardware for loose or missing nuts, bolts, screws, etc., and tighten or replace as needed.
6. Inspect hydraulic lines for damage or leaks. Never use hands to inspect leaks.
7. Check hydraulic oil level.
8. Inspect steering, throttle and shift linkages for good hookups and clear travel.
9. Check anti-vibration mounts on engine frame.
10. Check controls for smooth, proper working operation. Lubricate as needed.