Smithco Diesel Super Rake 17-001 Maintenance Manual - Manual (Page 18)

16
" WHEEL CREEP "ADJUSTMENTS
WHEEL ‘CREEP’ ADJUSTMENT
‘Creep’ is when engine is running and hydrostatic transmission is in neutral, but due to inadequate alignment,
wheels still move. Do the following procedures to stop this motion.
1. Lift up and support machine so all wheels are off the ground and can turn freely.
2. On the hydrostat pump there is a "creep arm" or a ball bearing inside a centering arm. Loosen bolt (A).
3. With engine running adjust the creep arm in the slot so centering arm centers on the swash arm.
4. Tighten all fasteners and test by using foot pedal linkage to see that the "creep" is removed.
5. Turn engine off and lower machine.
SUPER STAR
SUPER RAKE
DIESEL SUPER RAKE
X-TREME DIESEL X-TREME