Using the smartcontrol software (continued), Using rs-232 control (continued) – Smart Avi DVR16X16 User Manual
Page 10
USING THE SMARTCONTROL SOFTWARE (continued)
Router Count:
Set to the number of routers connected to the computer.
Advanced Configuration:
This option is used when there is more than one
router being used or when all the inputs are not looped from router to
router. For most applications, this box is usually unchecked.
Reset Advanced Configuration:
Returns the advanced setting to their de-
fault settings.
Router Type:
Select the type of router that is connected to the computer.
Inputs:
Enter the number of physical inputs on the back of the router.
Outputs:
Enter the number of physical outputs on the back of the router.
Note: Inputs and outputs are automatically configured when the router
type is chosen. These parameters are changed when router type is not
available on the list.
COM Port:
Choose the correct com port number that connects to the router.
Router Timeout:
Set how many seconds the program will wait for the router
to respond to commands. The default is 0.2 seconds.
Comm Type:
This option is set automatically when the router type is se-
lected.
When finish with the settings, click OK. This will take you to the Main Rout-
ing Window.
USING RS-232 CONTROL (continued)
To display the help menu for a list of commands, type “?
DBG>?
=========================================================
Command Line Interface Help:
To switch ports, type “sw [output] 1-16[input] 1-16
DBG>sw 2 2
Switched Output 2 to Input 2
To set the broadcast port, type “br [input] 1-8
DBG>br 2
To manage the EDID modes, type “edid
lowing prompt:
DBG>edid
EDID Mode:
EDID>
To learn the EDID, type “learn
EDID>learn
Successfully learned EDID!
To set the EDID to factory default 1920x1080, type “PC-1080
EDID>PC-1080
Successfully learned EDID!
To set the EDID to factory defaults, type “PC-1200
EDID>PC-1200
Successfully learned EDID!
d
Enable/Disable debug
d [on][off]
sw
Switch Port
sw [output] 1-16 [input] 1-16
br
Broadcast Port
br [input] 1-16
om
Set output mode
om [output] [mode# (0-2) | ?]
o
Enable/Disable Output
o [output] [0 = disable | 1 = enable
q
Query Crosspoints
h
Toggle Hotplug
h [input]
reset
Restore Factory Settings
boot
Reboot matrix
info
Display matrix info
edid
Manage EDID
help
Command list
?